All glow plugs replaced, 6 newbies all running OK The worst were the LH front and the RH rear but we got there in the end Ran the scanner over it and cleared all of the codes and it seems to be running OK. My numbering of each glow plug comes from a drawing that I printed out from the Technical Publication that I purchased.
The LH front No 1, remove engine cover, remove 2 x Tork bolts holding a small electrical coonection box and move out of the way, cut zip tie holding other tubing against fuel rail (I think) and then remove glow plug electrical connector, use long 8mm socket and flexible knuckle and 3/8 drive ratchet to remove.
The RH rear No 6, remove engine cover, remove RH engine cover retaining bracket (10mm bolt), remove glow plug electrical connector, then use 8mm long socket and small extension bar and insert at the back of electrical wires carrier and remove with 3/8 drive ratchet.
Opposite of each case to replace the glow plugs. I hope this may help.....
The rest are all pretty straight forward I thought so if you need to change them, either one or all, seriously it is not too hard and you don't need to give your money to the stealerships to
__________________
Take my advice ..... I'm not using it
|