Been drawing up a few designs for a custom hard top I want to build. Got a pretty good idea if how ill do it.
It's actually going to be a half top. Wondering if anyone else has one or attempted to make one and what issues they ran into. I'm conteplating how to do the rear tray cover so it opens but the roll bars could cause an issue having to go through it.
Also how to do the rear window. Was thinking having the rear window slot in and seal between the middle roll bar. That way it misses the side bars.
Roof seems pretty simple, make a frame and cover it with sheet. Ill use the windscreen mounting hardware from a soft top to clamp it at the front and figure out how to use the screw pins for the side windows to do the same. Hopefully that'll pull it down nice and tight around the body (once I run some rubber seal around too
What are people's thoughts?