Hi Team
A few years ago I asked about the camera in the front windscreen. See post:
https://www.ausjeepoffroad.com/forum...rd+lane+camera
On the Uconnect, under "Controls", the camera icon has always been greyed out.
About 2 years ago I had to replace my windscreen under warranty by the RAC here in Perth. No problems with them. They used Novus to do the replacement at my house. They said they had to calibrate the "screen". OK, so they poured water over it and all was OK.
Now, two weeks ago the windscreen developed a crack again, so contacted RAC, who now put me on to O'Brian. Went there this morning and waited for it to be replaced. After a while, the service person came to see me and told me they cannot proceed, because their scan showed an error with the Forward Facing Camera Module (FFCM), so they cannot do a calibration afterwards. I now need to take the car to JEEP to check this.........
I connected my AlfaOBD and checked the code, and yes, under the Forward Facing Camera Module section, code C008E comes up. Cleared it, but comes back again.... See pic of AlfaOBD.
I checked if Rockauto has the module (Lane Departure Camera / Module), but no stock
https://www.rockauto.com/en/moreinfo...=19944&jsn=870 Found some on the internet, and goes for around the $500 - $600.
In saying this, will the fault be with the actual module?
Any suggestions please?
Thank heaps!
Eddie