What did you do to your WK Grand today?

[GCRob]

Noice, could have you drilled out the holes little and it would have made it fit up better with the ORA pre runner? I want a ORA pre runner.

Also I've got a Trailhawk so does anyone know if the front plate will fit with the MOPAR plates? Do I need the transmission plate?

[Grippy]

Originally Posted by GCRob

Noice, could have you drilled out the holes little and it would have made it fit up better with the ORA pre runner? I want a ORA pre runner.

Also I've got a Trailhawk so does anyone know if the front plate will fit with the MOPAR plates? Do I need the transmission plate?

Nah, the plates fit perfectly, it was the Pre Runner that needed a nudge,I did manage to loosen the sucker just enough to squeeze it over.
I'm assuming the front would fit with the Mopar plates, these bolted up to the stock locations, right where the crappy rubber plates fit so assuming the Mopar skids bolt to the same spot

[Taprod]

Today I installed the off-road animal nudge bar and recovery points. It is about 3 years since I did anything to this vehicle. Turns out having kids is expensive!

Next up will be a pair of Stedi driving lights, followed by a murch snorkel




Sent from my iPhone using Tapatalk

[Mudguard]

Bugaya Taprod! didn't won't to see that! I'm still waiting for my BITS! haha

[OLMATE]

Hi Taprod did you remove the whole front bar or just the lower section to allow installation of the brackets, as Im heading down the similar path I would like to hear from someone whos been there done that rather than go in half arsed, any info no matter how trivial would be greatly appreciated, Cheers
Looks good by the way, is the bar alloy or stainless

[Taprod]

Originally Posted by OLMATE

Hi Taprod did you remove the whole front bar or just the lower section to allow installation of the brackets, as Im heading down the similar path I would like to hear from someone whos been there done that rather than go in half arsed, any info no matter how trivial would be greatly appreciated, Cheers
Looks good by the way, is the bar alloy or stainless

Thanks mate, It’s steel. I took the lower fascia off, so the unpainted plastic part.

Off-road animal gives pretty decent instructions and it was a reasonably simple install. Took my time and did it in about 90 min.


Sent from my iPhone using Tapatalk

[Grippy]

Originally Posted by Taprod

Today I installed the off-road animal nudge bar and recovery points. It is about 3 years since I did anything to this vehicle. Turns out having kids is expensive!

Next up will be a pair of Stedi driving lights, followed by a murch snorkel




Sent from my iPhone using Tapatalk

Looks good mate. Are you getting the pre runner too?
I quite like the Off-road Animal gear, have been close to pulling the trigger on their rear bar, or the rock rails with the high lift jack points, hmm, either way it's a lot more coin to blow